Magentis and Optima repair since 2000 of release
1. Engines
1.1. Engines of 2,0 l of DOHC
1.2. Engines of V6 2,5 l
1.2.1. Specifications
1.2.2. Compression check
1.2.3. Adjustment of gaps of valves
1.2.4. Gear belt
1.2.5. Check and adjustment of a tension of poliklinovy belts
1.2.6. Tightening of bolts of fastening of a head of the block of cylinders
1.2.7. Head of the block of cylinders, valve and spring of valves
1.2.8. Engine support
1.2.9. Removal and engine and transmission installation
1.2.10. Camshafts
1.2.11. Hydraulic jacks of gaps of valves
1.2.12. Pistons and rods
1.2.13. Cranked shaft
1.2.14. Block of cylinders
1.2.15. Air filter of the V6 engine
1.2.16. Broad air chamber
1.2.17. Inlet collector
1.2.18. Final collector
1.2.19. Exhaust silencers
1.2.20. Search and elimination of malfunctions
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
15. Electric equipment
16. Electric circuits
 










1-2-3-regulirovka-zazorov-klapanov.html

1.2.3. Adjustment of gaps of valves

Because the drive of inlet and final valves is carried out via hydraulic jacks of gaps of valves, adjustment of gaps of valves is not required. Normal functioning of hydraulic jacks of gaps of valves is determined by absence of knock of valves at operation of the engine. If there is a knock of valves, check hydraulic jacks of gaps of valves, pressing them and defining extent of their compression.


«on a step back
1.2.2. Compression check
on the following page»
1.2.4. Gear belt