Magentis and Optima repair since 2000 of release
1. Engines
1.1. Engines of 2,0 l of DOHC
1.2. Engines of V6 2,5 l
1.2.1. Specifications
1.2.2. Compression check
1.2.3. Adjustment of gaps of valves
1.2.4. Gear belt
1.2.5. Check and adjustment of a tension of poliklinovy belts
1.2.6. Tightening of bolts of fastening of a head of the block of cylinders
1.2.7. Head of the block of cylinders, valve and spring of valves
1.2.8. Engine support
1.2.9. Removal and engine and transmission installation
1.2.10. Camshafts
1.2.11. Hydraulic jacks of gaps of valves
1.2.12. Pistons and rods
1.2.13. Cranked shaft
1.2.14. Block of cylinders
1.2.15. Air filter of the V6 engine
1.2.16. Broad air chamber
1.2.17. Inlet collector
1.2.18. Final collector
1.2.19. Exhaust silencers
1.2.20. Search and elimination of malfunctions
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
15. Electric equipment
16. Electric circuits
 










1-2-5-proverka-i-regulirovka-natyazheniya-poliklinovykh-remnejj.html

1.2.5. Check and adjustment of a tension of poliklinovy belts

 PERFORMANCE ORDER

1. Check a condition, a tension and an arrangement on pulleys of a poliklinovy belt.

Moment of an inhaling of a bolt of fastening of the mechanism of a tension : 20–27 N • m

2. Establish a belt in the following order: generator pulley pulley of the pump of the amplifier of a wheel pulley of a cranked shaft pulley of the compressor of the conditioner

3. A key on 16 mm turn the lever of the mechanism of a tension clockwise (approximately on a corner 14 °) and put on a belt a single pulley.

4. At belt installation on a pulley, be convinced of correctness of an arrangement of a belt on a pulley.

5. The index of the mechanism of a tension should be between labels of the minimum and maximum situation, otherwise replace a belt.


«on a step back
1.2.4. Gear belt
on the following page»
1.2.6. Tightening of bolts of fastening of a head of the block of cylinders