Magentis and Optima repair since 2000 of release
1. Engines
1.1. Engines of 2,0 l of DOHC
1.2. Engines of V6 2,5 l
1.2.1. Specifications
1.2.2. Compression check
1.2.3. Adjustment of gaps of valves
1.2.4. Gear belt
1.2.5. Check and adjustment of a tension of poliklinovy belts
1.2.6. Tightening of bolts of fastening of a head of the block of cylinders
1.2.7. Head of the block of cylinders, valve and spring of valves
1.2.8. Engine support
1.2.9. Removal and engine and transmission installation
1.2.10. Camshafts
1.2.11. Hydraulic jacks of gaps of valves
1.2.12. Pistons and rods
1.2.13. Cranked shaft
1.2.14. Block of cylinders
1.2.15. Air filter of the V6 engine
1.2.16. Broad air chamber
1.2.17. Inlet collector
1.2.18. Final collector
1.2.19. Exhaust silencers
1.2.20. Search and elimination of malfunctions
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
15. Electric equipment
16. Electric circuits
 










1-2-9-snyatie-i-ustanovka-dvigatelya-i-korobki-peredach.html

1.2.9. Removal and engine and transmission installation

 PERFORMANCE ORDER

1. Remove the storage battery.

2. Remove the air filter.

3. Disconnect electric sockets from plaits of wires of the engine.
4. Disconnect electric sockets from the generator and the sensor of pressure of oil.
5. Merge cooling liquid.
6. On the car with an automatic transmission disconnect hoses of an oil radiator of a transmission.

Mark hoses before their detachment not to mix them at repeated accession.


Be careful, that transmission liquid from hoses did not flow out. For an exception of hit of dirt close the ends of hoses jams.

7. Disconnect the top and bottom hoses from a radiator and remove a radiator.

8. Disconnect all high-voltage wires from the coil and the ignition distributor.
9. Disconnect from the engine a wire of connection with "weight".
10. Disconnect a vacuum hose of the vacuum amplifier of brakes.

11. Disconnect from the engine hoses of giving and fuel return.

Gasoline is extremely inflammable, at work with elements of fuel system using fire, sparking устройства­ми, by open fire-dangerous light devices and smoking is forbidden. It is necessary to avoid emergence an iskreyoniya at the address with wires and elekyotrichesky devices.

12. Disconnect hoses of system the coolings going to a heater.

13. Disconnect from the engine a cable of an accelerator and a system cable cruise control.

14. Disconnect a cable of management of a transmission.
15. Disconnect from a transmission a cable of a drive of a speedometer.

16. Remove a hose of the oil pump of the amplifier of a wheel.

17. Lift the car.
18. Remove protection of the oil pallet.
19. Merge oil from a transmission.

20. Disconnect a forward exhaust pipe from a final collector.

Soft wire fix an exhaust pipe on the car bottom.

21. Turn out bolts of fastening of the spherical hinge of the bottom lever, then separate the spherical hinge of a tip of steering draft from a rotary fist.

22. Mount, pull out internal hinges of power shafts from a transmission.

After a detachment of power shafts from a transmission for an exception of hit of pollution close openings suitable jams.

Before installation of power shafts replace lock rings.

23. Support the engine the load-lifting mechanism.

24. Remove a forward support of the engine.

25. Remove a back support of the engine.

26. Disconnect wires from a starter.
27. Turn out bolts of fastening of the bottom (podmotorny) frame.

28. Turn out bolts and nuts of fastening of the bottom frame to a body.

29. Slowly lift the engine and a transmission and temporarily leave them in this situation.

Check that all electric sockets, hoses, tubes and plaits of wires are disconnected from the engine.

30. Turn out bolts of fastening of an arm of a transmission.

31. Remove the left support.

32. Rejecting a transmission down, remove the engine together with a transmission from the car.


«on a step back
1.2.8. Engine support
on the following page»
1.2.10. Camshafts