Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
12.1. Specifications
12.2. Anti-blocking system of brakes
12.3. Check and adjustment of provision of a pedal of a brake
12.4. Check of the vacuum amplifier of brakes
12.5. Pumping of hydraulic system of a drive of brakes
12.6. Pumping of hydraulic system of a drive of brakes with scanner use
12.7. Adjustment of a course of the parking brake
12.8. Brake pedal
12.9. Main brake cylinder
12.10. Vacuum amplifier of brakes
12.11. Brake tubes and hoses
12.12. Pressure regulator
12.13. Replacement of forward brake shoes
12.14. Support of a forward brake
12.15. Back drum-type brakes
12.16. Replacement of the working brake cylinder
12.17. Back disk brakes
12.18. Support
12.19. Hydraulic HECU block (the hydraulic and electronic control device)
12.20. Sensor of frequency of rotation of a wheel
12.21. Parking brake
12.22. Search and elimination of malfunctions
13. Body
14. Central air
15. Electric equipment
16. Electric circuits
 










12-6-prokachka-gidravlicheskojj-sistemy-privoda-tormozov-s-ispolzovaniem-skanera.html

12.6. Pumping of hydraulic system of a drive of brakes with scanner use

Pumping of hydraulic system of a drive of brakes with use of the scanner is necessary for carrying out for ensuring adequate pumping and filling of the block of hydraulic management, tubes of brake system and the main brake cylinder.

 PERFORMANCE ORDER

1. Uncover a compensatory tank with brake liquid.

Brake liquid dissolves paint, plastic and isolation of wires therefore at casual hit of liquid on a paint and varnish covering of the car or its components wash out them a large amount of water.


When pumping under pressure do not press a brake pedal. Recommended brake liquid: DOT 3

2. Unscrew a cover from the union of pumping and attach to it one end of a transparent hose, and other end of a hose insert into the glass capacity of sufficient volume half filled with brake liquid.

3. Connect the scanner to the diagnostic socket located under the dashboard.

4. According to the maintenance instruction of the scanner choose the corresponding parameter.

To exclude a peregoraniye of the electric motor of the pump consider the maximum operating time of ABS at work with the scanner (60 c).

5. Slowly press a brake pedal several times. At the pressed pedal of a brake a key weaken the union of pumping and wait, brake liquid without air vials yet will not start to leave. Tighten the union of pumping and release a brake pedal.

6. Repeat a step 5 for air removal from brake mechanisms of other wheels.

7. Tighten the pumping union.

Inhaling moment: 7–9 N • m


«on a step back
12.5. Pumping of hydraulic system of a drive of brakes
on the following page»
12.7. Adjustment of a course of the parking brake