Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
12.1. Specifications
12.2. Anti-blocking system of brakes
12.3. Check and adjustment of provision of a pedal of a brake
12.4. Check of the vacuum amplifier of brakes
12.5. Pumping of hydraulic system of a drive of brakes
12.6. Pumping of hydraulic system of a drive of brakes with scanner use
12.7. Adjustment of a course of the parking brake
12.8. Brake pedal
12.9. Main brake cylinder
12.10. Vacuum amplifier of brakes
12.11. Brake tubes and hoses
12.12. Pressure regulator
12.13. Replacement of forward brake shoes
12.14. Support of a forward brake
12.15. Back drum-type brakes
12.16. Replacement of the working brake cylinder
12.17. Back disk brakes
12.18. Support
12.19. Hydraulic HECU block (the hydraulic and electronic control device)
12.20. Sensor of frequency of rotation of a wheel
12.21. Parking brake
12.22. Search and elimination of malfunctions
13. Body
14. Central air
15. Electric equipment
16. Electric circuits
 










12-9-glavnyjj-tormoznojj-cilindr.html

12.9. Main brake cylinder

Removal

 PERFORMANCE ORDER

1. Disconnect tubes of brake system from the main brake cylinder and close the opened openings suitable jams.

Brake liquid dissolves paint, plastic and isolation of wires therefore at casual hit of liquid on a paint and varnish covering of the car or its components wash out them a large amount of water.

2. Unscrew nuts of fastening of the main brake cylinder and remove the main brake cylinder.

Dismantling

 PERFORMANCE ORDER

1. Remove a stopper and merge from a tank brake liquid.

2. Remove a tank from the main brake cylinder.

3. Remove a lock ring.

4. Remove a piston stopper (only ABS).
5. Get the primary piston.

6. A screw-driver press the secondary piston and remove a piston stopper (only ABS). Get the secondary piston.

Do not assort primary and secondary pistons.

Check

 PERFORMANCE ORDER

1. Check an internal surface of the case of the main brake cylinder on lack of a rust and development.
2. Check the main brake cylinder on lack of wear or damages. If necessary clear or replace the main brake cylinder.

  1. If the opening of the case of the main brake cylinder is damaged, replace the main brake cylinder assembled.
  2. For removal of pollution clear the case of the main brake cylinder isopropyl alcohol.

Assembly

 PERFORMANCE ORDER

1. Grease with the recommended brake liquid an internal surface of the main brake cylinder and external surfaces of primary and secondary pistons.

2. Accurately insert two springs and pistons into an opening of the main brake cylinder.

3. Press pistons and establish holding ring.

4. A screw-driver press the piston and establish a lock ring in a flute of diameter of boring of the main brake cylinder.

5. Establish two basic condensing rings and with effort insert a tank into sealing rings of the main brake cylinder.

6. Establish a cover on a tank.

Installation

 PERFORMANCE ORDER

1. Measure a vystupaniye of a pusher and adjust (8,25±0,125 mm).
2. Establish the main brake cylinder on the vacuum amplifier of brakes.
3. Connect brake tubes to the main brake cylinder.
4. Fill in brake liquid and remove air from a hydraulic contour of brake system.


«on a step back
12.8. Brake pedal
on the following page»
12.10. Vacuum amplifier of brakes