Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
14.1. Specifications
14.2. Service of central air of air
14.3. Remarks at replacement of elements of central air of air
14.4. Connection of elements of central air of air
14.5. Connection of elements with a directing pin
14.6. Installation of manometers for pressure measurement
14.7. Pumping of atmospheric air from central air
14.8. Connection of the final valve to a cylinder with a coolant
14.9. Charging of central air of air
14.10. Oil for greasing of the compressor of the conditioner
14.11. Check of hoses and tubes
14.12. Compressor noise
14.13. Check and adjustment of a tension of poliklinovy belts
14.14. Verification of operational characteristics
14.15. Sensor of threefold pressure
14.16. Check of the relay of the fan of the condenser
14.17. Check of the switch of the conditioner
14.18. Check of the switch of modes
14.19. Switch check fresh / retsirkuliruyemy air
14.20. Conditioner compressor
14.21. Plug of coupling and pulley of the compressor of the conditioner
14.22. Coil of initiation of coupling
14.23. Fan and condenser
14.24. Check of the engine of the fan
14.25. Search and elimination of malfunctions
14.26. Check of the relay of central air of air and condenser fan
14.27. Check of the relay of the fan of a heater
15. Electric equipment
16. Electric circuits
 










14-14-proverka-ehkspluatacionnykh-kharakteristik.html

14.14. Verification of operational characteristics


 PERFORMANCE ORDER

1. Establish a manometer to the highway.
2. Start the engine, leave to work at frequency of rotation of a cranked shaft of 2000 mines–1 and establish a mode of the maximum cooling at high frequency of rotation of the fan.
3. Open all windows or doors.
4. Establish the dry thermometer in a lattice of supply of air in car salon.

5. Establish damp and dry thermometers as it is possible closer to an entrance opening of the block of cooling.

6. Check that the pressure shown by a manometer, is in limits of 1,373-1,575 kPas. If pressure too high, pour water on the condenser. If pressure too low, close the forward party of the condenser.
7. Check that air temperature in a lattice of supply of air in salon of the car is in limits 25–35°C.

8. According to the schedule calculate relative humidity of air, comparing temperature of damp and dry thermometers.

9. Take temperature in a lattice of supply of air in salon of the car and calculate a difference between the dry thermometer and the thermometer in a lattice of supply of air.
10. Check that if crossing of relative humidity and a difference of temperatures are in admission limits, means, central air of air works normally.


«on a step back
14.13. Check and adjustment of a tension of poliklinovy belts
on the following page»
14.15. Sensor of threefold pressure