Sensor of threefold pressure. KIA Magentis/Optima (since 2000 of release)
Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
14.1. Specifications
14.2. Service of central air of air
14.3. Remarks at replacement of elements of central air of air
14.4. Connection of elements of central air of air
14.5. Connection of elements with a directing pin
14.6. Installation of manometers for pressure measurement
14.7. Pumping of atmospheric air from central air
14.8. Connection of the final valve to a cylinder with a coolant
14.9. Charging of central air of air
14.10. Oil for greasing of the compressor of the conditioner
14.11. Check of hoses and tubes
14.12. Compressor noise
14.13. Check and adjustment of a tension of poliklinovy belts
14.14. Verification of operational characteristics
14.15. Sensor of threefold pressure
14.16. Check of the relay of the fan of the condenser
14.17. Check of the switch of the conditioner
14.18. Check of the switch of modes
14.19. Switch check fresh / retsirkuliruyemy air
14.20. Conditioner compressor
14.21. Plug of coupling and pulley of the compressor of the conditioner
14.22. Coil of initiation of coupling
14.23. Fan and condenser
14.24. Check of the engine of the fan
14.25. Search and elimination of malfunctions
14.26. Check of the relay of central air of air and condenser fan
14.27. Check of the relay of the fan of a heater
15. Electric equipment
16. Electric circuits
 










14-15-datchik-trojjnogo-davleniya.html

14.15. Sensor of threefold pressure

The sensor of threefold pressure represents the combined switch of low pressure (to check quantity of a coolant), average pressure (for turning on of the fan of the condenser) and a high pressure (for overheat prevention).

The sensor is established in the receiver and when pressure becomes approximately equal 200 kPas or less, the condenser fan, thus, excepting a compressor overheat is switched off. When pressure reaches 3214 kPas, the compressor is switched off.


«on a step back
14.14. Verification of operational characteristics
on the following page»
14.16. Check of the relay of the fan of the condenser