Transceiver installation. KIA Magentis/Optima (since 2000 of release)
Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
15. Electric equipment
15.1. Specifications
15.2. Charging system
15.3. Power failure check on a wire connecting the storage battery to the generator (V6 engine)
15.4. Check of the current developed by the generator
15.5. Check of developed tension
15.6. Power failure check on a wire connecting the storage battery to the generator (the engine of 2,0 l)
15.7. Check of the current developed by the generator (the engine of 2,0 l)
15.8. Check of developed tension (the engine of 2,0 l)
15.9. Generator
15.10. Storage battery
15.11. Survey of the storage battery
15.12. Start system
15.13. Removal and starter installation
15.14. Transceiver installation
15.15. Removal and installation of remote control
15.16. Removal and audioblock installation
15.17. Multipurpose switch
15.18. Safety locks
15.19. Combination of devices
15.20. Switch of position of the parking brake
15.21. Heater of back glass
15.22. Screen wiper and stekloomyvatel of a windscreen
15.23. Safety cushions (SRS)
15.24. Precautionary labels
15.25. Safety cushion of the driver and spiral wire
15.26. Safety cushion of the forward passenger
15.27. Search and elimination of malfunctions of system of a charging
15.28. Search and elimination of malfunctions of system of start of the engine
16. Electric circuits
 










15-14-ustanovka-priemoperedatchika.html

15.14. Transceiver installation

The electronic control system was developed so that external radio-waves did not render on it essential influence. However, if the aerial or a cable of the amateur transceiver are established about control units by car systems, they can have harmful effects, even if target capacity of the transceiver no more than 25 W.

For protection of electronic control systems against impact on them the working transceiver, it is necessary to fulfill the following requirements.

 PERFORMANCE ORDER

1. Establish the aerial on a roof or a rear bumper.
2. As radio-waves also are radiated from a coaxial cable of the aerial, lay it at distance not less than 200 mm from control units and plaits of wires. If the cable crosses a plait of wires, arrange it so that it settled down at right angle to a plait of wires.
3. The aerial and a cable should be well coordinated and the ratio of a standing wave should be low.
4. The transmitter with big target capacity should not be established in the car.


«on a step back
15.13. Removal and starter installation
on the following page»
15.15. Removal and installation of remote control