|
Disconnect an air inlet hose from throttle knot and check a butterfly valve surface on absence of deposits of soot. For removal of deposits of soot use aerosol solvent. |
1. Start the engine, warm up to working temperature and switch off it. 2. Disconnect an air inlet hose from throttle knot.
|
3. Close a stopper the channel for supply of air bypassing a butterfly valve.
|
Be convinced that solvent does not pass through the channel for supply of air bypassing a butterfly valve.
|
|
4. Spray clearing aerosol solvent via the inlet channel of throttle knot and wait for 5 minutes before its absorption. 5. Start the engine and several times increase frequency of rotation of a cranked shaft, then leave the engine to idle. 6. Repeat steps 4 and 5. 7. Remove a stopper closing the channel for supply of air bypassing a butterfly valve. 8. Establish into place an air inlet hose.
|
9. Disconnect a "weight" wire from the storage battery for the period of more than 10 seconds. |
10. Adjust frequency of rotation of a cranked shaft idling.
|