Magentis and Optima repair since 2000 of release
	1. Engines
	2. Greasing system
	3. Cooling system
	4. Control and decrease in toxicity
	5. Fuel system
	6. Ignition system
	7. Coupling
		7.1. Specifications
		7.2. Pumping of hydraulic system of a drive of coupling
		7.3. Coupling pedal
		7.4. Main cylinder, tube and coupling hose
		7.5. Main cylinder of coupling
		7.6. Working cylinder of coupling
		7.7. Casing and coupling disks
		7.8. Search and elimination of malfunctions
	8. Transmission
	9. Power shafts, axes
	10. Suspension bracket
	11. Steering
	12. Brake system
	13. Body
	14. Central air
	15. Electric equipment
	16. Electric circuits

cam chat

7-sceplenie.html

7. Coupling

PERFORMANCE ORDER

1. Measure distance from a forward surface of a pedal to a carpet. A hand press a coupling pedal before emergence of notable resistance and measure size of a free wheeling.

Free wheeling of a pedal of coupling (And): 1–3 mm

2. If the free wheeling of a pedal of coupling does not correspond to demanded value, adjust it.

Weaken a lock-nut and, rotating a bolt, adjust a free wheeling of a pedal of coupling, then tighten a lock-nut.

After adjustment tighten a bolt while it will not reach a pedal emphasis, then tighten a lock-nut.

Rotate a pusher before achievement of a demanded free wheeling, then tighten a lock-nut.

At adjustment of height of installation or a free wheeling of a pedal of coupling be careful not to move a pusher to the main cylinder of coupling.

3. After completion of adjustments check that the distance from a coupling pedal to a floor at the pressed pedal corresponds to demanded value.

Free wheeling of a pedal of coupling (In): 6–13 mm

4. If it is impossible to adjust height of installation and a free wheeling of a pedal of coupling, probably in hydraulic system of a drive of coupling there is an air or the main cylinder of coupling is faulty. In this case remove air or disassemble and check the main cylinder of coupling.

«on a step back
6.10. Search and elimination of malfunctions of fuel system

on the following page»
7.1. Specifications