Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
8.1. Mechanical transmission
8.1.1. Specifications
8.1.2. Check of level of oil
8.1.3. Replacement of transmission oil
8.1.4. Replacement of an oil sealing ring of a power shaft
8.1.5. Gear shifting lever
8.1.6. Removal and transmission installation
8.1.7. Transmission shaft
8.1.8. Entrance shaft of a transmission
8.1.9. A conducted shaft of a transmission
8.1.10. Search and elimination of malfunctions of coupling
8.2. Automatic transmission
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
15. Electric equipment
16. Electric circuits
 










8-1-10-poisk-i-ustranenie-neispravnostejj-scepleniya.html

8.1.10. Search and elimination of malfunctions of coupling

Probable cause

Elimination method
Vibration, noise
  1. Damage of fastening of a transmission and bottom frame
  2. It is increased axial люфт in bulk
  3. Gear wheels are worn-out or damaged
  4. Use of not recommended oil
  5. Low level of oil
  6. Inadequate frequency of rotation idling
  1. Tighten fastenings
  2. Adjust a gap
  3. Replace
  4. Fill in the recommended transmission oil
  5. Add oil
  6. Adjust frequency of rotation idling
Leakages of oil
  1. Sealing rings are damaged
  1. Replace sealing rings
Moving of the lever of gear shifting is complicated
  1. The management cable is faulty
  2. Violation of contact or wear of a konusny surface of the synchronizer and gear wheel
  3. The synchronizer spring is weakened
  4. Use of not recommended oil
  1. Replace a management cable
  2. Replace
  3. Replace a synchronizer spring
  4. Fill in the recommended transmission oil
Spontaneous switching off of transfer
  1. Forks of gear shifting are worn-out or the tarelchaty spring is broken
  2. Excessive gap of the plug of the synchronizer
  3. Are worn-out either the damaged gear wheels and / or bearings
  1. Replace a fork or a spring
  2. Replace the synchronizer plug
  3. Replace the synchronizer plug

«on a step back
8.1.9. A conducted shaft of a transmission
on the following page»
8.2. Automatic transmission