8-1-8-vkhodnojj-val-korobki-peredach.html
8.1.8. Entrance shaft of a transmission
Dismantling
|
1. Using the special tool (09432-21300) remove a spring ring and the ball bearing.
|
2. Remove a lock spring ring, a lock ring, gear wheels of the 5th and 4th transfers, the needle bearing, the plug of a gear wheel of the 4th transfer, a synchronizer ring (the 3rd and 4th transfers), synchronizer springs (the 1st, 2nd, 3rd, 4th transfers), synchronizer plugs (the 3rd and 4th transfers), a gear wheel of the 3rd transfer and the needle bearing. |
|
|
Check
|
1. Check the surface of an entrance shaft contacting to needle bearings on existence of damages or abnormal wear.
|
2. Check shlitsa of a shaft on existence of damages or wear. |
3. Establish the synchronizer plug on the plug and be convinced that it moves smoothly. 4. Check the plug on existence of damages.
|
5. Check wear of surfaces of end faces of the plug (contacting to each gear wheel).
|
Replace the plug of the synchronizer and the plug as a set.
|
|
|
|
Assembly
|
|
1. Using the special tool (09432-33300) establish the needle bearing, a gear wheel of the 3rd transfer, the synchronizer plug (the 3rd and 4th transfers), springs of synchronizers (the 1st, 2nd, 3rd, 4th transfers), a synchronizer ring (the 3rd and 4th transfers), the plug of a gear wheel of the 4th transfer, the needle bearing, gear wheels of the 5th and 4th transfers, a lock ring and a lock spring ring. |
|
2. Using the special tool (09432-21300) establish the ball bearing and a spring ring. |
|
|
|
|