Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
8.1. Mechanical transmission
8.2. Automatic transmission
8.2.1. Specifications
8.2.2. Check of level of liquid in an automatic transmission
8.2.3. Liquid replacement in an automatic transmission
8.2.4. Replacement of the oil filter
8.2.5. Check of conductivity of the switch of ranges of a transmission
8.2.6. Check of conductivity of the switch of a sports mode (F4A42–2 2,0 and 2,5 l)
8.2.7. Switch of ranges of a transmission and adjustment of a cable of management
8.2.8. Check of components of an automatic transmission
8.2.9. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
8.2.10. Diagnostic codes
8.2.11. Diagnostics function
8.2.12. Inspection card of codes of diagnostics
8.2.13. The inspection card for determination of malfunctions
8.2.14. Adjustment of an axial gap of a reactionary brake
8.2.15. Adjustment of an axial gap of a brake of the second transfer
8.2.16. Adjustment of an axial gap of a brake of low transfer and backing transfer
8.2.17. Adjustment of an axial gap of a solar gear wheel of lowering transfer
8.2.18. Adjustment of preliminary loading of differential
8.2.19. Elements of a control system of a transmission
8.2.20. Removal and transmission installation
8.2.21. Transmission repair
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
15. Electric equipment
16. Electric circuits
 










8-2-14-regulirovka-osevogo-zazora-reakcionnogo-tormoza.html

8.2.14. Adjustment of an axial gap of a reactionary brake

Axial gap: 0–0,16 mm

Fix press a disk of a brake of the lowest transfer and backing transfer by the special tool and establish a brake disk, and a spring ring as is shown in drawing. Establish a reactionary plate and a spring ring. Move the special tool to measure an axial gap and then replace a spring ring to adjust an axial gap to standard size.


«on a step back
8.2.13. The inspection card for determination of malfunctions
on the following page»
8.2.15. Adjustment of an axial gap of a brake of the second transfer