Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
8.1. Mechanical transmission
8.2. Automatic transmission
8.2.1. Specifications
8.2.2. Check of level of liquid in an automatic transmission
8.2.3. Liquid replacement in an automatic transmission
8.2.4. Replacement of the oil filter
8.2.5. Check of conductivity of the switch of ranges of a transmission
8.2.6. Check of conductivity of the switch of a sports mode (F4A42–2 2,0 and 2,5 l)
8.2.7. Switch of ranges of a transmission and adjustment of a cable of management
8.2.8. Check of components of an automatic transmission
8.2.9. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
8.2.10. Diagnostic codes
8.2.11. Diagnostics function
8.2.12. Inspection card of codes of diagnostics
8.2.13. The inspection card for determination of malfunctions
8.2.14. Adjustment of an axial gap of a reactionary brake
8.2.15. Adjustment of an axial gap of a brake of the second transfer
8.2.16. Adjustment of an axial gap of a brake of low transfer and backing transfer
8.2.17. Adjustment of an axial gap of a solar gear wheel of lowering transfer
8.2.18. Adjustment of preliminary loading of differential
8.2.19. Elements of a control system of a transmission
8.2.20. Removal and transmission installation
8.2.21. Transmission repair
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
15. Electric equipment
16. Electric circuits
 








canadian online pharmacies

8-2-18-regulirovka-predvaritelnojj-nagruzki-differenciala.html

8.2.18. Adjustment of preliminary loading of differential

Place solder (about 10 mm in length of 3 mm in diameter) on a hydrotransformer casing as is shown in drawing.

Establish a hydrotransformer casing to a transmission case, without using hermetic. Tighten bolts the moment of the inhaling recommended by the specification. Turn out bolts and remove solder. Use a micrometer for measurement of thickness (T) of the compressed solder. Choose the laying which thickness is in limits of the calculated value.

Standard thickness: from (mm T+0,045) to (mm T+0,105)


«on a step back
8.2.17. Adjustment of an axial gap of a solar gear wheel of lowering transfer
on the following page»
8.2.19. Elements of a control system of a transmission