Magentis and Optima repair since 2000 of release
1. Engines
2. Greasing system
3. Cooling system
4. Control and decrease in toxicity
5. Fuel system
6. Ignition system
7. Coupling
8. Transmission
8.1. Mechanical transmission
8.2. Automatic transmission
8.2.1. Specifications
8.2.2. Check of level of liquid in an automatic transmission
8.2.3. Liquid replacement in an automatic transmission
8.2.4. Replacement of the oil filter
8.2.5. Check of conductivity of the switch of ranges of a transmission
8.2.6. Check of conductivity of the switch of a sports mode (F4A42–2 2,0 and 2,5 l)
8.2.7. Switch of ranges of a transmission and adjustment of a cable of management
8.2.8. Check of components of an automatic transmission
8.2.9. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
8.2.10. Diagnostic codes
8.2.11. Diagnostics function
8.2.12. Inspection card of codes of diagnostics
8.2.13. The inspection card for determination of malfunctions
8.2.14. Adjustment of an axial gap of a reactionary brake
8.2.15. Adjustment of an axial gap of a brake of the second transfer
8.2.16. Adjustment of an axial gap of a brake of low transfer and backing transfer
8.2.17. Adjustment of an axial gap of a solar gear wheel of lowering transfer
8.2.18. Adjustment of preliminary loading of differential
8.2.19. Elements of a control system of a transmission
8.2.20. Removal and transmission installation
8.2.21. Transmission repair
9. Power shafts, axes
10. Suspension bracket
11. Steering
12. Brake system
13. Body
14. Central air
15. Electric equipment
16. Electric circuits


8.2.21. Transmission repair

The transmission represents very difficult unit and its repair it is necessary to carry out in a specialized workshop. Also at removal and installation of many details it is necessary to measure gaps and, if necessary, to adjust them for what use of the corresponding adjusting laying and washers is necessary. Not only that details of a transmission are absent on sale and they are necessary for ordering, they are still extremely expensive. If the transmission is faulty or works with strong noise, it is desirable to charge repair of a transmission to the expert or to replace a transmission that can cost cheaper considerably. However the part of malfunctions of a transmission can be eliminated without removal of a transmission from the car.

However, despite all difficulties, the skilled expert can make repair of a transmission and in house conditions. Thus it is necessary to have special tools and to perform work consistently, step by step noting the executed operations. At repair of a transmission it is necessary to use special flat-nose pliers for removal of lock rings, strippers for bearings, an inertial hammer, a set of punches, a micrometer and a hydraulic press.

Before removal of a transmission try to define most precisely malfunction of a transmission that further considerably will facilitate repair.
«on a step back
8.2.20. Removal and transmission installation
on the following page»
9. Power shafts, axes