9-3-privodnojj-val-so-shrusami-sharikovogo-tipa-i-birfield-tipa.html
9.3. A power shaft with CV JOINTS of ball type and type Birfield
Dismantling
|
|
For greasing of CV JOINTS use only special greasing.
At assembly of the CV JOINT it is necessary to establish new collars.
|
1. Remove collars and pull together protective covers from CV JOINTS D. O. J. and B. J. power shaft.
|
Be careful not to damage a protective cover.
|
2. Remove a collar and a lock ring of the CV JOINT D. O. J.
|
3. Remove a spring ring, an internal ring of D. O. J., CV JOINT D case. O. J. and balls as block. |
4. Without dismantling clear an internal ring of the CV JOINT D. O. J., case and balls.
|
Be careful, that balls did not drop out of the case.
If balls dropped out of the case, insert them back into the CV JOINT D case. O. J. also fix an internal ring.
|
5. Wipe lubricant with шлицов.
|
6. Remove from CV JOINTS a protective cover of D. O. J. and B. J.
|
If the protective cover is repeatedly used before cover removal for its protection, wrap up shlitsa of a power shaft a sticky tape.
Do not assort the Birfield type CV JOINT.
|
|
|
|
Check
|
1. Check a condition шлицов a power shaft. 2. Check on lack of traces of a rust, water and extraneous subjects in a protective cover of the Birfield CV JOINT.
|
3. Check the ball CV JOINT D. O. J. on lack of traces of a rust, damages of an external ring, an internal ring and balls.
|
|
|
Assembly
|
1. Before cover installation for its protection wrap up shlitsa of a power shaft from the ball hinge (D. O. J.) sticky tape. 2. Put greasing on a power shaft and establish a cover.
|
4. Fill an internal part of covers of CV JOINTS of Century of J and Century of J with the recommended lubricant. The recommended lubricant: CENTOPLEX of 278 M/136 K
Quantity:
In the hinge of 2,0 l of MKP: 60±3 g
In a cover of 2,0 l of MKP: 60±3 g
In the hinge of 2,5 l of MKP: 70±3 g
In a cover of 2,5 l of MKP: 65±3 g
|
|
5. Fill an internal part of covers of CV JOINTS D. O. J and D. O. J the recommended lubricant.
The recommended lubricant: CENTOPLEX of 278 M/136 K
Quantity:
In the hinge: 65±3 g
In a cover: 40±3 g
|
6. Establish the CV JOINT D case. O. J, balls, internal ring and spring ring.
|
7. Establish a power shaft in the CV JOINT D case. To O. J also establish a lock ring. |
|
8. For adjustment of amount of air in the CV JOINT D. O. J fix covers so that the length of a power shaft corresponded to demanded values Length of the left power shaft:
With MKP of 2,0 l: 687,6±2 mm
With MKP of 2,5 l: 679,4±2 mm
Length of the right power shaft:
With MKP of 2,0 l: 1000,62±2 mm
With MKP of 2,5 l: 679,4±2 mm
|
|
|
|
|